Multi-process generator. MIG/MAG Synergetic pulsed and double pulsed with two torches. Focused on bodywork, achieving exceptional results on low-thickness aluminium and stainless steel.
JOB TRIO 220 LAB is equipped with 3 welding torches for welding on steel, aluminium or brazing (CuSi3/CuAl8) simultaneously.
Simply press the button on one of the torches to activate the welding program.
JOB TRIO 220 LAB delivers 220 Amp direct current (DC). The power supply voltage is single-phase 230 Volt.
Job TRIO 220 LAB offers 3 welding processes always at hand: MIG/MAG, MMA, and TIG LIFT.
MIG/MAG welding can be done using PULSED / DOUBLE PULSED methods for steel, stainless steel, aluminum, and wire for brazing.
Low-thickness aluminum and stainless steel can be achieved with exceptional results using MIG pulsed and double-pulsed.
The Synergic control is extremely effective. All the main welding parameters are connected and act in a combined way to obtain a welding quality usually found in more sophisticated products.
The control panel is very simple to facilitate use in synergic and manual modes. The machine is pre-installed with a standard package of over 20 programs. An SD card can be used to update the software.
The color graphic control panel is easy to use and can be used in either simple or advanced modes. The machine has a pre-installed standard package of over 20 programs for different types of material, diameter, and gas. Additionally, the software can be updated through an SD card.
The TIG LIFT welding process, using a torch with a tap to control the protective gas, allows for minute processing on mild steel and stainless steel sheets of small thickness.
In TIG welding with LIFT arc striking, the tungsten electrode is placed on the surface to be welded and by lifting it slowly to strike the welding arc. The passage of low intensity current allows not to ruin the electrode while the welding machine progressively increases the amperage.
In electrode welding MMA Job TRIO 220 LAB can be used with rutile and basic electrodes from 1.6 to 4.0 mm in diameter with excellent ignition properties and a stable arc. It is suitable for welding of mild steel and stainless steel.
Code: 250600
Comes complete with:
-Torch EP 25 ALU – 230A 3m aluminum ready (010074) (Tip Ø 1,0 mm), rollers (Ø 1,0 / 1,2 mm Al).
– Torch EP 15 – 180A 3m steel ready (010234) (Tip Ø 0,8 mm), rollers (Ø 0,6 / 0,8 mm Fe),
– Torch EP 15 – 180A 3m Cu.Si3 ready (010071) (Tip Ø 0,8 mm), rollers (Ø 0,6 / 0,8 mm Fe)
– Cable 16mmq with ground clamp (2,7 m), gas hose (1,5 m).
